canabus
Basic
canabus’s harbour
6 boats(Pleasure Craft) Precedent Huntsman 34"
I bought it with a Merco 40/electric starter/radio as an unfinished boat. Changing over the brushless elect…
(Fire Boat) Vosper Crash Tender
I bought it cheap and in good condition, but with no running, driveline brushes required replacing, a repai…
(Racing Boat) Blue Vee
40 year old fibreglass hull finally finished. Using it for testing motors and props. (Motor: 3639-1100kv) (…
(Racing Boat) White Vee
Venom Ocean Racer converted from brush to brushless motor. ABS hull. Turned a lemon into very fast boat. (M…
(Racing Boat) No name
Plywood frame and skinned with balsa. Three coats of fibreglass resin on the outside and one coat inside. H…
(Pleasure Craft) Aerokits Sea Hornet
Building from the original plans(25 and 1/4 inch). One piece plastic windscreens, customized engine and rea…
canabus’s build blogs
6 blogsHi All I hope you all enjoyed the build. Regards Canabus
Hello Shipmates Well thanks to Zooma I have a hull to work with and its in good order. But me been-ing me I am removing a lot of nails. R…
Hi All This was a restoration project from last year !!! It was at best a basket case,but, I had to have one. It looked bad and when it a…
Hi All As the owner of two Hellen fishing boats, I was looking for something with better access, but, about the same size. I found the Fr…
Hi All This year I bought an unstarted kit, but, sold it to a club member. A month later one of the club member wish to swap for a faster…
Hi All Started on all the side, rear and front windows. Installed all the running gear and radio. The windscreen is going to be fun to ma…
Followers
4 followersRecent uploads
Latest activity
Last posted 1 hour ago
♥ 7 likesRe: build blog@chugalone100 This one is a LOT easier than the Sea Rover which was a real basket case!!! Harry♥ 2 likesRe: build blog@zooma HI Bob I off set the prop shaft knot the rudder. Harry♥ 2 likesRe: Aerokits Sea UrchinYou can get flat servos like for ailerons for airplanes which slide back and forwards. These would between last frame and the transom. Harry♥ 3 likesRe: build blogHi Me Lads Well another week and a few more bits done. Whilst making the motor mount which is knot my favorite thing in built boats. But it all worked out OK for once !!! I must be getting better at it ??? I h…
♥ 2 likesRe: build blogWell Lads The final finish of the Sea Rover and it was put in the water. It ran spot on, no trimming at all. Good turn of speed and turns both ways great. It did off set the prop shaft. Harry
+4♥ 5 likesRe: BOELE - How did you fair?WE did the RIB tour, but knot a lot of dolphins more whales !!! Was that the boat shed at Franklin ??? Harry♥ 4 likesRe: build blog@zooma Hi Bob No the roof comes off the wheelhouse windscreen. It was a total pain to setup !!! So to install the battery I remove the stern bench seat, the split stern flooring. The two supports for the stern…
♥ 2 likesRe: build blog@zooma Forward cabin roof on, note I changed the roof line to go back to the windscreen. With the main windscreen in place I had started the HARD part, the removable stern roof. Harry
♥ 3 likes