… mber to take some video for me. This is a hobby King Tunnel hull boat, running a brushless motor and 11.1v 3 cell. The weather was a bit windy, hence the rough sound, the water too was slightly choppy, any worse and I would of not run the b …

… is is my 1/24th scale S80 Schnellboot,it has a Metcalfe GRP hull,the superstructure is a mix of 3mm/4mm ply and 2mm plasticard,it has 3 x Graupner 600FG motors that have a 3.1 ratio gearboxes fitted,the props are 55mm witches hat type,and i …

… the photo with rest of fitting which were on the boat. The hull paint work and decals are the original one that came with the boat, the motor which came fitted to the prop is a Johnson made in Hong Kong.So if some can tell me the approx, y …

… 1/64 scale . At 6 feet long . Scratch built on a fibreglass hull from plywood plastic card & metal parts . Works on a six channel futaba skysport . Full working red & white leds on deck and cabin , lynxs helicopter with working rotor blades …

… nticipated as the deck had started to part company from the hull. After stripping the deck of all remaining deck furniture the deck was re laminated to the hull, prop shafts and rudder tubes also refitted using plenty of resin and cloth. A …

… as original as possible so converted from IC to electric, repainted the lower hull, new stainless inner propshaft, made some handrails and fitted the lights. it was very dirty but has cleaned up a treat. I'm running a Darke Horse 700 with a …

… be remade, deck/superstructure/roof panels/windows etc. The hull needed stripping back to give a good surface for the finished paint work. Completion of the basic boat is now getting near, and ready for fitting out with motor radio etc. Hop …

… ,Finally got started on the fireboat. Have stripped all the paint and varnish from the deck up and also inside the hull. Now have separated all the cabin roofing and upper bulkheads for access to the keel which has delaminated in places. Th …

… ill plans, available still from Brown,Son and Ferguson. The hull was mahogany on 6mm ply frames. The engine was a Caton from Maxwell Hemmens supplied bya gas-fired Cheddar Puffin boiler. The propeller was a two inch four bladed brass job fr …

… tly finished MTB may be of interest. It consists of 49" GRP hull ply deck / superstructure. The fittings are from a mixture of ABS and metal, to give a good surface for spray painted finish. The drive consists of twin 850 motors and twin 50 …

… by Gray (Froggyt996). First he had to skin one third of the hull as only two thirds had been skinned. He then had to use copious amounts of filler to make the hull its correct shape see photo 3, instead of the stepped hull as per the origin …

… he water only goes in to it and not in to the bottom of the hull, it seems to work ok and there are several ways you can do it. this is pre Paint

… kit Fast Patrol Boat. When I bought the boat it had a sound hull with a few damaged fittings, which I removed. Since then I have made new guns, extended the front cabin to carry the life raft to make it look like a late World War II Elco PT …

The hull of this model was my own design in 2004 and was sailed for 2 years, and then a new upper decks and battery system were added during the winter of 2005. The hull performed well enough but my original cabin design was too crude to ke …