Tortola at rear, Curlew in foreground.
Tortola plank (Balsa, tissued and dope) on frame, the keel and bulkheads from 10mm plywood. it has a small electric motor fitted but will have sails as well. Curlew from the Eezibuilt range. Material ply wood, Some of it from fruit crates.
The stand for Tortola made from 3 ply cardboard to my own design, stuck together with PVA glue.

The way that I do my hull plating is......to use printer paper about 90gsm, and divide the hull up into approriate lines horizontal and vertical to represent the plating once the hull is sanded and smooth of course.
then cut the paper into the sizes that you need to represent the hull plating.
then thin down waterproof PVA glue so that is like double cream and then to represent the plate joggling lay each piece onto the edge of a steel rule so thar about 1/8th is overlapping and then run your thumb nail along the edge of the rule this will give you a joggled edge, repeat if you need more than one joggle per plate, have a practice first and see how easy it is.
then just stick tmen onto the hull using the PVA glue remembering to overlap the joggles ( I like that word). Easy peasy.
once every thing is really hard and dry ,give the paper two or three coats of the PVA all over and it dries like glass.