pilot boat, made from kauri strip planks and then glassed.bowsprit slides in for transport and mast comes out.
Small motor to get you home if no wind.

strip planked in kauri and then glassed.2.1reduction with elecric 12 volt power.it is a danish fisherys protection boat.

Scratch built in 1/16 scale in 2016 on a modified GRP hull. Powered by one 385 electric motor. Sail her on Mary Stevens Park Pool, Stourbridge.
Though built in the 1950's this boat is still in use on the Norfolk Broads and can be hired out.

Maggie m weathered like my boats to look like really thing

This is Creepy,a springer tug that is 5 yrs old now.He pushes #1200lb pumpkins for the pumpkin regatta along with saving many of the PMPBA club members boats from certain sinking or floating away.I never go to any of the club floats without him.He runs a Harbor freight 550 motor running a Target Hobby 320amp ESC,on a 5000mah 2s lipo battery.The plans can be downloaded free off the internet and takes about a week to build for the experienced builder,Great for the new boat builders to do because its an easy build tug.Simple door skins,some balsa,1/2a running gear from Dumas,1.5 brass prop,2x2 rudder from aluminum,cheap 2channel radio,ESC from Target Hobby.

This is my first boat, Club500, with the very cold temp of late and our local water frozen I had to wait till this week to have my first go and I am very happy with it, roll on summer 😉

I have had my Paula III for quite a few years and she was beginning to look a bit jaded, so having just completed my Northlight Clyde Puffer and looking for something to do, thought that I might give Paula a makeover. Nearly all the additions I made to her were from spare parts left over from making other boats. A good strip and rub down and a couple of cans of aerosol (colours chosen by my wife when in Halfords) and 2 weeks later - makeover complete.

It is wooden boat.

It is 85 cm long, RC fishing boat. Engine is 0.15 cc nitro. it is not a kit, hundred percent hand made.

Since one grandson had a boat with his name on, his brother wanted on too! This shrimp boat became Timothy's with a guiding hand from grandpa when at the lake. Tim is four years old.

My grandson Michael helped me build this kit last winter. We had fun researching existing tug boats of the era, and upgrading some of the details. After the bath tub test, I changed from direct drive to a 3:1 ratio motor to keep it running at a scale speed.

New crew member on board yesterday - caught him having a sit down!