This is my Aerokits Solent Class Lifeboat that was rescued from Ebay as a wreck see photo's 1 & 2. This was then lovingly restored for me by Gray (Froggyt996). First he had to skin one third of the hull as only two thirds had been skinned. He then had to use copious amounts of filler to make the hull its correct shape see photo 3, instead of the stepped hull as per the original Aerokits build. He then had to put the superstructure together as it had fell apart whilst being posted to us as it had been put together with a hot glue gun yuk!!!!!! Next started the painting as shown in photo 4. Please see my next post for the next stages of its rebuild.
Marie (alias Mrs Froggyt996)

The boat is a scratch built and started life in the shed. it is a semiscale model at aprox 36inch, built with balsa wood.It is full remote control and fitted with two Mtroniks Vision 600 motors one 12volt 7ah battery,one seasprint esc.
It was built as a fun boat so I could sail with my friend Peter thomas with his variuos boats.
Several things have now been added since this boat was first built, IE smoking stacks, fireing torpedoes and magnetic pickups for colecting them. Also has working radar/moving gun + a home built bec.
Flag poles and flags/compas has been added on the superstructure.
Each motor draws 6amps at full power, I have measured the speed from one point to another at a spacing of 60mtrs, and timed at 15 seconds, but this is a bit fast for this boat as she starts to plane out of the water.
We sail her at New Brighton lake on the wirral most wednesdays. As the weather is now a bit cool I have just purchased a simular model to this at 1:48 scale 110ft island class USCG Patrol boat so I can look at them both in action when the weather picks up. Anyone wanting info can contact me via this website.

This model is a British "Hunt" Class destroyer.

It is a Sirmar limited edition (100) semI kit at 1/48 scale and some 6 feet in length. When he bought the model it was already constructed, but as a static model. So out came the jigsaw, Manual NOT powered.

The deck around the aft gun turret was cut to allow a good inspection of the inside of the hull. He tried to remove the bridge superstructure but this would have meant destroying it to remove. Out came the jigsaw again and cut an access hatch in the main deck.

The steering servo was fitted and attached ( by keyhole surgery ) and 2 x MFA 800 motors were fitted. Scale Prop Shop Props were fitted and the radio gear just jury rigged for her first trial. She was roughly ballasted with 2 x 12volt 7Ah batteries and she was ready for her first trials.

She sailed well with no water ingress to the hull, so the radio gear was installed properly with individual speed controllers to each motor. The results are as seen here.

This lifeboat was a part-kit from Metcalfe Mouldings, being just a bare hull and superstructure. All the detailed work was scratch- built by my son and I did all the drive and electrics.

It is powered by two 540 motors through a single water-cooled speed controller and the props are about 35mm. My son and I sail it at our club water at Knightcote in Warwickshire. it is now about 4 years old and, (touch wood), pretty reliable.