Club members light up their boats at sunset for the Lighthouse Nights

Brian Clewes brought along a nice example of his scratch built Master Hand retired fishing boat, for a sail. When larger more powerful mechanised boats were introduced this type was abandoned. Many were rescued and turned into pleasure / racing type craft and that is what this model depicts. Not seen for some years but is ageing well. The static pics will be of interest to any modeller considering making a scale sailing ship of this type. I did film some video and will share this later when edited.
enjoy
Dave

Nice calm night last night, so thought I'd go down an disturb the peace. Camera battery must have been going flat as the sound/picture sync was miles out, but you'll get the idea, (the sound is ahead of the picture by about 4 seconds) Might try for a better one when it's lighter and the battery is fully charged. YT also distorts a good video in the transfer for some reason (my HD camera anyhow)

On Halloween morning Sunday Oct. 31 2021 ran the Sequin with several other club members at Spencer's pool may be last run this year with weather getting cooler . The lake freighter was her first run & just needed a little ballast weight at the stern prop wasn't deep enough Boat belongs to a fellow club member .

Wasn't a bad day today after a week of rain and storms (the 4ft sand bank was almost level with the creek before the storm, creek's moved 30ft sideways, - normally tidal right up under the bridge) so I took the airboat out for a thrash. Bit hard going up the creek with all the rocks exposed and shallow spots,- stopped a number of times. Lot of fun but not a lot of room to manoeuvre. I'm going to do it again on a calm day when the tide's in, and go out to sea a bit.

Here we have a selection of boats sailing amongst the autumn colours at the "Pavilion Gardens Lake " Buxton, Derbyshire in early October 2021.
Music is from Bensound - "The lounge".

Sun was out, wind was down, so took the boat for swimming lessons. Went very well, no problems other than the silicone couplings trying to screw themselves off as usual, (too much bite and torque) and bunching up to the motor causing friction), (have a possible fix I'm working on for that today) Heaps of power from the 2 - 540 HV brushed motors only running on 3s. Never went much more than a tad past 1/2 throttle which was spot on scale wise.

Very quiet as well, - mind you, couldn't hear much anyhow with a road milling machine working at the end of the pond about 150m away, at around 80db where I was!!😠😠😠😭 Of course it would have to be there today,! something like this always stuffs my plans up, cars, trucks, screeching seagulls, people talking to you while you are trying to make a nice quiet video etc etc. Can't seem to get away from noise. Added to that, the video's crap,- as soon as it uploads to YT it turns to rubbish,- was quite acceptable till then.

Must be the wide format they use, as it's fine in a small screen (ie YT preview) and my computer. Worst thing is, it took an hour to load this rubbish on a fibre connection!! Not loading any more till I get a better camera, "Santa, did you hear that ?"😁

I might de-power it a bit, as it has too much power really,- might put 2 540 45T motors in which will run on 2s nicely with 30mm props (has 35s at the moment) and not be as touchy on the throttle. You can steer this just using the throttles it's so bitey. Spins on the spot like a jet boat as well. Stereo worked well, but the IR remote doesn't like working too far away in bright sunlight, (have a separate vid, but YT would give a copyright warning, so I won't put that up) The vid is garbage, but you'll get the idea😁

Ever felt sorry for those Philipino static models you see all over the place? Well I did and bought this launch from a charity shop in Didcot for a fiver. I reckoned that the fittings were worth that even if the change to working model failed. Fortunately, the model floated about right as it was and I managed to save a lot of weight to allow for the added weight of motor/batteries/ rc gear etc.

The project has not been without its problems but it should be finished and ready to maiden within a couple of weeks. Not sure that I would do this again but it has been interesting......... I intend to mount it on a boat trailer rather than a stand. Report more when she is launched.

Another " Montage of Memories " of RC Sailing at the Pavilion Gardens Buxton with members of the Buxton Model Boat Club - August / September 2021.

Here we have a " Montage of Memories " of RC Sailing with the Buxton Model Boat Club though the month of July 2021.

Scratch built motor gun boat from Bangladesh.
Tried my best to upgrade it into a brushless one. First attempt was brushed and it was kind of a pain in the ass.
It runs far better now.

The Loganville is out of the water for its annual inspection and scrapping before being repainted.
Here is my model of it.