Photos & videos

Sign in to share

Search results

2,041 posts · Page 20 of 171
philcaretaker
Commodore
Grahams Gaff Rigged Pilot Cutter !
On the water again, Graham starts to evaluate his Gaff Rigged Pilot Cutter.
Filmed 20th June 2021 - onboard with Grahams fixed cam, and with Gopro from my camera boat.

Grahams "Build Blog" can be seen here :-
https://model-boats.com/blogs/86653

Also more photos here :- https://model-boats.com/places/60518

Phil.
Liked by vosper and GaryLC and
2 comments
  • jbkiwiFleet Admiral
    Good video Phil, Graham's done a great job and she sails really well and looks the part. Must set my airboat up with a decent camera sometime.

    JB
    Liked by Graham93 and Martin555
  • Martin555Fleet Admiral
    I like the video Phil,
    Graham's Ellen really looks good on the water.

    Again excellent work Graham.

    Martin555.
    Liked by Graham93
jbkiwi
Fleet Admiral
FAIRACRE BROADS CRUISER, NEW MOTOR AND ESC
Fitted the new 550 45T brushed motor as a replacement for the ancient and slow 70s Graupner monoperm. Goes a lot better now and has a decent speed range. Handles and rides quite well for a skinny boat. Prop is a Graupner 40mm 2 blade (don't know the pitch, -fairly fine) Using a 2200mAh 2S LiPo battery which probably gives around an hours running slowly, or 30 mins of hooning around.

Battery was only charged to 8.25v and ended up at 7.7v. (45%) after about 3/4 hr. I'll probably fit a Hobbywing ESC as well, for a bit better reverse action, as the El cheapo car one is a bit slow finding reverse at times.
Liked by MouldBuilder and Brightwork and
Rogal118
Captain
brave borderer 4th sea trial!
Typical yorkshire weather, after 5 minutes it chucked it down so had to make a quick retreat. used just one 2200 3s lipo for now but need a bigger lake/pond really as can only give full power for 3-4 seconds, so stop -go is not good but was hoping to get some good photos-videos, but the rain stopped play till another day.
Edit, forgot to mention. most of run on centre prop only. the last 5 seconds or so is full power, well nearly.
Liked by SimpleSailor and MouldBuilder and
3 comments
  • RowenCaptain
    Looks good Roger,
    Whilst the comments on paralleling LI-POs are correct. I have never had an issue. I have used two identical cells and fully charge each separately until the charger cuts out.
    Would never try two partially discharged cells as then the current might flow from one to the other creating the overcharge rate problem
    Recently decided that rather than use two cells, why not use one at once? This reduces weight and eliminates the concern.
    Think you need a larger pond! Glad to see the weather is consistent with my memorys.
    Rowen
    Liked by Scratchbuilder and jbkiwi and
  • jbkiwiFleet Admiral
    Hi Roger, goes so well on one, you could have left the other two motors out!

    JB
    Liked by RNinMunich and Rogal118 and
Rogal118
Captain
Brave Borderer 2nd trial, new battery
I've replaced the old 6v sealed wet battery with a lipo 3s,11.1 volt 2200mhz, 100c spectrum smart battery. so the 1st run was cautious i just fired up the centre prop to see how she performed, well i was surprised at the turn of speed she had on just 1 prop, and how well she planed, it was a little awkward filming and controlling the boat by myself as i was the only one pond side. this was not without mishaps though, see 2nd video
After checking the boat over she was found to be unmarked and no bits missing, not bad to say she hit the pontoon at full speed, took off and plunged back in at the other side.
So the second run i started on the centre prop and then opened her up on the outer 2, she shot forward and immediately stalled, dead in the water. luckily i could reach her with the ponds barge pole to pull her to the side. i found the fuse had blown , i had fitted a 20amp mini flat fuse, i didn't have a 30amp only another 20amp which blew just as quick, upon opening up the outer props.
any ideas anyone or will a 30amp do the job, or a 2s battery? help any suggestions considered.
Roger
Liked by T33CNO and Colin H and
7 comments
  • Rogal118Captain
    Hi Ronan
    Thanks for your input.
    Its starting to make sense now.
    I bit the bullitt and bought a lipo battery and charger. I ended with a spectrum smart 2200mhz,3s, 11.1v,100c.i had a choice of a 30c but thought it may not be man enough for 3 motors so looked at the 50c, but was out of stock, so i ended with the 100c it was the same price as the 50c anyway. The charger was a spectrum smart type to. This monitors the battery and hopefully does everything automatically.
    Once again thanks for your help and encouragement
    Roger
    Liked by jbkiwi and Martin555
  • RowenCaptain
    Hi Roger,
    You are learning well! A similar road to the one I travelled a couple of years ago.
    Hard to see the fuse block on my Brave now, but here is one am assembling for my next project. Got my fuse blocks off Banggood, they offer both 4 and 6 fuse ones.
    Used a 6 on the Brave as wanted a fuse per motor, currently using 30 A capacity. Should protect the 50 A ESCs. Bigger fuses and even re-settable ones can be fitted into the block if warranted.
    The home made buss bar and battery connector are visible.
    Hope this helps.
    Rowen
    100C should be more that adequate, mine is 30C. You should be able to drive a welder with it too!
    Liked by Rogal118 and Martin555
RNinMunich
Fleet Admiral
Sea Scout 'Jessica' Sea Trial - at last!
Part 1. ideal conditions; nearly 30°C, cool Bier at hand😜
Sea Scout built by Dad in the early sixties with a Taycol Target and 6V lead acid wet cells (very wet😡). Renovated and dragged into the 21st century over the last several months 😉
See Build Blog 'Sea Scout 'Jessica'' for details!
Motor: Propdrive 2830, 1000kV, 30mm 3 blade Raboesch prop. Quicrun 16BL30 (30A) ESC with BEC.
Tested with 3 battery types, all started with 99% measured capacity-
1. NiMh 4.2Ah 7.2V, nom. 408gm.
Result: Speed sedate (OK 😉scale river cruising!) No planing.
Max current: 3.6A
End status V / capacity left: At end of short run ca 3 mins. 7.78V 99%.
2. 2S LiPo 4.0Ah 7.4V nom. 257gm.
Result: Speed still sedate but due to lower batt weight at least the forefoot came out of the wet stuff! Max current: 4.1A
End status V / capacity left: At end of short run ca 3 mins. 8.25V 93%.
3. 3S LiPo 4.0Ah 11.1V nom. 315gm.
Result: Now we're getting somewhere!!😁
Good speed, manoeuvrability and planing 😊 Max current: 7.5A
End status: 11.95V 74% after several long runs, ca 20 mins total.
Estimated (extrapolated) endurance on a 4Ah LiPo around one hour - mostly 'full bore' - 'Pedal to the metal man' 😊

See also:

The competition!

Final run. (Beer was getting warm😁)

Cap'ns log entry:
Boat dead-weight w/o battery: 1.8kg.
Spray rails to be added!😲
Slight list to port to be trimmed.
Rudder servo to be reversed!!😲
Keel protection to be added: some scratches and flaking from stony sloping shore 🤔
Summary: much as expected👍 Forget anything less than 3S.
Anyone want to buy a batch (4) of new 2S 4Ah 45C Lipos? 'One careful owner'!
Happy boating people, Cheers Doug 😎
PS Many thanks to Camera girl Gisela 👍
Recorded in 1080p HD.
Liked by River Rat and Wez and
19 comments
  • RNinMunichFleet Admiral
    Hi Will,
    The videos were all taken at stage 3. 'Now we're getting somewhere' with the 3S LiPo.
    As depicted in the report there wasn't anything worth filming on either the 7.2V NiMh or the 7.4V 2S LiPo. Plod plod boring! I wasn't really surprised. I just wanted to know 😉
    Cheers, Doug 😎
    Liked by Madwelshman
  • MadwelshmanLieutenant Commander
    I suspected it was on the 3s in the video.
    Thanks for that Doug.

    Will
tomarack
Sub-Lieutenant
1 / 4
RC model Lulonga river tug
I built this model during four long years. my Lulonga is nearly whole scratchbuilt model (about 75 cm long) except the steering wheel and position lamps.
The model has a plywood and balsa hull construction ,plywood decks,from hard polystyrene sheets made superstructure,laminated with veneer. Sidewheels with skew paddles, two DC 12V independent electric motors with gearboxes controlled by ESC. Electric LED lights, steam sound module, sirene and horn.Tx/Rx 6 channel HK 2,4GHz.
completion expected in spring 2014
More infos about building you find at > www.paddleducks.co.uk <

some videos are here at Model Boats too >
http://mdlbt.com/19852

wiring diagram you can see here in my albums
http://tomarack.rajce.idnes.cz/RC_model_Lulonga#lulongaelschema1.jpg
Liked by billmcl61 and RNinMunich and
2 comments
  • AlanPLieutenant
    Very nice looking model tamarack 👍
  • ZdenekAble Seaman
    Nice model, Tom 👍
jbkiwi
Fleet Admiral
HARTLEY TOW VEHICLE, BOAT RAMP, HANDBRAKE TEST No 2
Short vid of 2nd handbrake test with a 3kg load (simulating boat) works well, vehicle pulls it up the ramp no trouble, (end cut as cam batt ran out)
Liked by Colin H and Graham93 and
2 comments
  • Martin555Fleet Admiral
    Jb,
    The weather looked nice so I think you just like driving around with the trailer on the back. LOL!!

    Or was it a case of "Dam I forgot to pack the boat"

    Martin555.
    Liked by jbkiwi and Colin H and
  • jbkiwiFleet Admiral
    Martin, the bumper sticker says, "if you can read this, I've lost the boat"😁, It was lots of fun
    playing and an excuse to get outside after the rain..😁

    JB
    Liked by Martin555
Ronald
Fleet Admiral
Provincial stay-at-home order starts tomorrow.
Ontario Premier Doug Ford's cabinet has approved a provincewide stay-at-home order and will close non-essential retail stores for all but curbside pickup, multiple sources told CBC News Tuesday night.

The move comes in the wake of criticism that restrictions announced last week — what the government called "emergency brake" measures — are insufficient to slow the spread of Ontario's third wave of COVID-19.

The Ministry of Health reported another 3,215 cases of the illness Wednesday morning, the most on a single day since Jan. 17, when the second wave was at its peak in the province. Health units also logged 17 more deaths of people with COVID-19, pushing the official toll to 7,475.

The seven-day average of daily cases has climbed to 2,988, its highest point since January 18.

The upward trend in new infections comes as the province logged a record-high day for vaccinations, with 104,382 doses administered yesterday, according to the ministry.
Liked by Ianh
3 comments
  • RonaldFleet Admiral
    Actually 3rd wave.
    Liked by RNinMunich
  • RNinMunichFleet Admiral
    Same here Ron ☹️
    Curfew from 22:00 to 05:00 was reinstated last Sunday 🤔
    Good excuse though to stay over at Gisela's over Easter 😊
    Shops and restaurants which were partially opened a few weeks ago are clamped down again.
    Garden centres to close down again from next Monday 😭
    On ON / OFF chaos here! I don't even want to mention the vaccination mess 😠
    Great photo BTW 👍
    Stay safe, Doug 😎
philcaretaker
Commodore
RC Sailing No.118 - Out of Lockdown ! . 4th April 2021
RC Sailing No.118 - Out of Lockdown ! . 4th April 2021
Forgot my gloves ! - Forgot to charge the boat ! - Forgot how to set Gopro ! - at least we got a few clips of video - out of lockdown al last !.
Nice to see Bill & Ben back sculling on the Pavilion Gardens in Buxton !.
Liked by Martin555 and Ianh and
6 comments
  • RNinMunichFleet Admiral
    Make a set of adaptors Ian 😉
    Then you can mix and match to your hearts content,😊
    as long as you don't forget to take the adaptors with you! 😭
    😎
    Liked by Martin555
  • jbkiwiFleet Admiral
    We've all done that sort of thing, Ian, 😁, I've got to the flying field or pond on numerous occasions, only to find I've brought the wrong battery, (or forgotten it) wrong TX (have 2 almost identical HK TXs) forgotten spanners, screw drivers, -you name it.

    JB
    Liked by Martin555

Liked by

Loading…

Delete this post?

It will be removed from the site.

Discard this draft?

Your draft will be deleted and cannot be recovered.

You have an unfinished draft

What would you like to do with it?