Another youtube offering, and also Danish as per the last video. A very neat steam engine installation of a twin cylinder slide valve, in an open hardwood boat. The three figures on board are to a very high standard and dressed very much the same as the last video. it would seem besides bacon, Denmark is the place to find one's authentic boat crew.

Found this on youtube and had to copy it onto here, the fine detail and the two figures in the boat are unbelievable. A standard to work up to hopefully. A pity the boat is not on the water, can't get over the incredible detail. Enjoy.

our new pool at the hooton park trust site ellesmere port

A nice afternoon and 5 bft with Gopro on board !
at the end of the day nothing damaged, ( but on the limit ..)

a compilation of a nice sailing afternoon in west kapelle (the netherlands) with a view underwater

here my robbe smaragd in heavy wind conditions !
sails like a beauty 😁 for an old big lady !

my first graupner carina named "juliette" under attack by crabs 😁

refitted Robbe Sirius IRC 88 (by stock maritime) completely new electronics and fittings, resprayed in 2k polyurethane topcoat

I bought the Moorcock from a fellow boater and decided to rebuild her as the Moorcock. The hull was stripped bare and the prop-shaft tube removed and completely remade with a new prop. The hull was then repainted and the life boat and davits added The superstructure was cleaned up and remade with a Robbe spring loaded grappling iron added to the rear deck.She is powered by a 24v scooted motor salvaged from a garbage bin and has 4 x 12v 7amh SLA's to provide power. She is a good strong vesel to sail and is often used as a recovery tug.

This is a 1:100 scratch build of an (unnamed) Fort/Park class freighter, based on Jim Pottinger's drawings of a North Sands design. I'm building this as a DEMS ship. it has smoke and an overboard water discharge (if it works!).

These ships were built in many Canadian shipyards during WW2. Some went to British Admiralty - with Fort XXX names - and some went to Canadian government - named for Can. parks.

I haven't yet decided on the name for this model.

total scratch built on fibreglass hull 127cm x24 cm,11 months to build 6volt system brushed motor,3blade 35mm brass prop.

Here's my Robbe smaragd, its about 30 years old and recently I have refitted some electronics. sailwinch replaced for the genua fore sail. it just did not function very well.
It sails like a beauty and very steady on coarse.