Isle Of Man Ferry TSS Manxman Scratch built in 1/87 scale in 2016 on a GRP hull. Powered by two 385 electric motors. Sail her on Mary Stevens Park Pool, Stourbridge

Scratch Built 1:32 scale Dover Harbour Board Tug, DHB Doughty.
The main hull is a standard Damen hull purchased from Mobile Marine Models, see their website for Portgarth.
the hull is fitted with 2 x T12 Motors for the main propulsion,2 x 60 degree kort nozzles for steering, with 2 x purpose made brass props.
Also fitted is a 12v Graupner water pump for the working fire monitor and Fwd spray bar, 2 x Mtronks 15 amp ESC's, Futaba steering servo and Futaba 40 MHz Receiver.
Approx Dimensions including fendering Loa 41" Beam 14"

Scratch built in 2015 on a GRP hull. Built as seen in 2013. Powered by two 385 electric motors. Sail her on Mary Stevens Park Pool, Stourbridge

1/128 Scratch Built on a GRP hull. Built her 20 Years ago and sail her on Mary Stevens Park Pool, Stourbridge.
Powered by four 385 electric motors

Maggie m weathered like my boats to look like really thing

This is Creepy,a springer tug that is 5 yrs old now.He pushes #1200lb pumpkins for the pumpkin regatta along with saving many of the PMPBA club members boats from certain sinking or floating away.I never go to any of the club floats without him.He runs a Harbor freight 550 motor running a Target Hobby 320amp ESC,on a 5000mah 2s lipo battery.The plans can be downloaded free off the internet and takes about a week to build for the experienced builder,Great for the new boat builders to do because its an easy build tug.Simple door skins,some balsa,1/2a running gear from Dumas,1.5 brass prop,2x2 rudder from aluminum,cheap 2channel radio,ESC from Target Hobby.

Hi MBW,s Tinplate clockwork torpedo/submarine propulsion is twin coaxial contra rotating props totally scratch built handmade. its about half way through the build at the moment just doing the clockwork ballast timer and compressed air system. Cant wait to chuck it in the oggin.

This is my first boat, Club500, with the very cold temp of late and our local water frozen I had to wait till this week to have my first go and I am very happy with it, roll on summer 😉

I have had my Paula III for quite a few years and she was beginning to look a bit jaded, so having just completed my Northlight Clyde Puffer and looking for something to do, thought that I might give Paula a makeover. Nearly all the additions I made to her were from spare parts left over from making other boats. A good strip and rub down and a couple of cans of aerosol (colours chosen by my wife when in Halfords) and 2 weeks later - makeover complete.

It is wooden boat.

It is 85 cm long, RC fishing boat. Engine is 0.15 cc nitro. it is not a kit, hundred percent hand made.

Please note that this kit includes Motors and couplings from Deans. All you need are the servos, speed controller and radio to complete this kit.