Built this Wave Princess 30 years ago meaning to use it with my children. Languished in attic since and now retired going to resurrect her for Grandchildren and would welcome any advice on motor size, prop shaft length, Propeller size etc etc. Picked up an as new MacGregor Digimac 111 transmitter receiver and servos at Boot Sale for £5, seems fitting I should use it for the old girl.

Filmed at Action Stations, Portsmouth Historic Dockyard.

Cormorants Perkassa undergoing sea trials

This is my 6 month in build of a fully working fishing boat .she has a real I have modified and put a 20kg winch servo so u can real in and out and have drill a hole in to the real and put another servo so u can lock the reel out to.made a back plate on the end of a cut off rod and bolted in to the hull. She has full fpv from the wheel house with a 360 spin HD camera and have even put a digital amp meter so u can look at to and see how mUchida power u have left full running lights controls off hand setc to twin brushless motor water cooled and a large 100 amp esc with air fan and own power supply going to take her out tomorrow for her maiden voyage. Witch has bin a real long time coming and a lot of blood sweat and stress to get it all to work but finally I'm there hope u all enjoy and like what I have dun thanks for reading my post Ben

Scratch built. Copy of Scottish fishing trawler with belt drive to propeller shaft from small electric motor

These little corvettes were the backbone of the Atlantic defence of the supply convoys from Halifax Canada to Britain from 1942 to 45
Here she is with steam engine engaged for checking before recent sailing complete with Asdic sound
This was used to echo signal of enemy submarines to pinpoint their position

Running brushless with 11.1v lipo at Mary Stevens Park in Stourbridge, West Midlands

A Canadian Coast Guard Icebreaker
Built 1967 @ Canadian Vickers Montreal
Currently owned by the Chilean Navy
The model was scratch built from the plans supplied by Marine Modelling int.
The model is to 1:120 scale and is 750mm long
The model is based on the original build of the vessel.

The original was built in 1956 on the Clyde, spent some time in Dundee where she was renamed The Scotscraig, she ended up in Ireland working on the Shannon in 1986 and named The Shannon Estuary 1

I bought a used hull of the Ayton Cross and look all over the internet for some plans but found none.
I did find a lot of images though.

I bought most if not all of the fittings and since have decided that the way to go is to make what you can from what I can get hold of.

So all other model boats are and will be scratch made.
I have two on the burner at the moment.

Anyway some of the Ayton Cross looks right some of it does not.

But I can always do it again as I hopefully get a little better.
This one again is awaiting Ballast and it will be ready to go.
I fitted two Engel 12 volt motors and made the mounts in grp then Laminated them into position..

Everything has been hand painted and slightly aged .

The bow thruster was made using some household plumbing pipe a small propshaft Again home made and it works very well.

Something to play with as I build hopefully better.

Well this is the 3rd version I have made of a springer tug.

Grp Hull and this time using 2 mm plastic.
Balsa wood and again what ever I could find laying around.

The decking is just printed paper and stuck down with Varnish.

Just needs some ballast and it is ready to go.

So this was attempt number two at a springer tug.. A little better than the very first one.

Again a home made grp hull and everything else Balsa wood and a few bits I could find about the house..

Well this one too has been scrapped and the hull reused.
Or set aside for another one at a later date.

So at this time is just a fitted out hull